LEYCO®-STRIP 2

Preparation of the dip:
The best baths in which to use LEYCO®-STRIP 2 have acid resistant surfaces. In addition, simple iron or steel tanks can be used, though it should be noted that after a period some corrosion may occur. When using the dip, the process will take longer when the atmospheric temperature is lower. The most favourable dip temperature is with approx. +20°C.
Application notes:
LEYCO®-STRIP 2 is applied in the dipping bath. Small parts are put suitably into a wire basket and submerged in to the
LEYCO®-STRIP 2. The time taken to remove the surface coat depends upon the type of varnish, its strength and the temperature of the dip. The accurate cleaning time can only be obtained by an experiment. The burned coating materials become detached splinter or float from the metal.
For economy reasons we recommend to build a false floor in the reservoir, so that the varnish residue can be removed occasionally without having to remove the liquid. This simple method ensures the high economy of LEYCO®-STRIP 2. After the cleaned parts are removed from the dip, they should be thoroughly hosed down with clean water.
This should take off any loosely adhered residue.

Density: 1,270 g/cm3 +/- 0,05
Appearance: liquid, yellowish
Dilution: none
Precaution: Dichlormethan Contains and Mono chlorine acetic acid 1% and 5%

UN-No.: 1593

DO NOT INHALE, SWALLOW OR ALLOW CONTACT
WITH SKIN. This may cause irreversible damage.
Wear suitable PPE – refer to data sheet for details. Keep out of reach of children. Keep in well sealed containers away from source of ignition sources. Avoid naked flame.
Do not allow to enter water courses.